Thanks:
0
Likes:
0
Dislikes:
0
-
C3380i with Z1 finisher not stacking correctly
I spent a couple of hours on this problem. When the paper exits the finisher it does not pull it back
in to stack. The sheets get skewed on something. I have not seen what it is getting skewed by.
It looks like I would have to remove the finisher to do just about anything.
So, has anyone had any experiences like this on that finisher?
Thanks
DR
-
Re: C3380i with Z1 finisher not stacking correctly
There are a couple of rubber arms that pull the paper back in, give them a good clean.
Best to remove this finisher rather that try & work on it in the machine, only a few screws unit comes out.
Also check you don't have limited functions mode on.
-
Re: C3380i with Z1 finisher not stacking correctly
Had this before, there are also little black rubber bands, very thin that sit in a groove on some white rollers, these break off and cause alot of issues when skewing. You will probably see one missing, easy enough to spot
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks