IRA C7260 empty waste toner message

[copier tech]

Right this may sound like a basic question but here goes, is this a customer replaceable item, its one thumb screw slide new bottle in etc but to reset the counter customer has to enter service mode? Or is there a reset in additional functions? 🤔

[CS0523]

I dont think that the customer should replace the bottle its not list as a consumable item for customer.
I look in the e-manual and cant find an function to reset the counter. (I have only the e-manual, sry)

[20 year tech]

see attachedTP10 371a.pdf

[copier tech]

see attachedTP10 371a.pdf

Thanks! Maybe this is not available to us in the UK.

Is there a part number for the label?

[20 year tech]

Thanks! Maybe this is not available to us in the UK.

Is there a part number for the label?

H
ere is a PDF of it

[Etech50]

This bulletin was for the 7000 series. The 7200 uses the same bottle but uses the reflector in the bottle to detect full not the window. There is a counter for waste but the message to empty comes from the sensor, not the count. If the customer is shown how to swap the full for an empty, that is all that needs to be done to get up and running.

[julka123]

Hi
Check this:

WT-FL-LM Wst tonr full warning dis timing set
Lv.1 Details To set the timing to display the waste toner full warning
message. Depending on the user's use condition (image duty),
the number of images to be printed until the Waste Toner
Container becomes full is different. By specifying the image
duty, the number of images to be printed until the toner full
warning message can be set.
If the image duty is approx. 10%, set to "1" since Waste Toner
Container becomes full with approx. 120,000 images (B&W).
Toner full warning message is displayed when the number of
images reaches the setting value or when the Waste Toner Full
Sensor is ON. If 4,000 images are printed further, the device
stops.
Use case When toner full warning timing is adjusted according to the
user's use condition
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution After replacing the Waste Toner Container, clear the counter
using W-TN-CLR.
Display/adj/set range 0 to 4
0: Image duty: 30% (B&W 40,000 images)
1: 10% (120,000 images)
2: 5 to 7% (240,000 images)
3: 3.75% or less (320,000 images)
4: Not used
Unit -
Appropriate target value -
Default value 1
Required time -
Related service mode COPIER> FUNCTION> CLEAR> W-TN-CLR