Canon imagepress C7010

[tbyabachwezi]

Hi guys. I have Canon imagepress c7010vp when I turn on the main switch only standby LED on screen light, if I press power button nothing happened. I tried to check all power supplies it seems ok.

Pls I need your help guys what could it be problem I'm ready to pay anyone who shows interest of helping

Here is my email tbyabachwezi@gamail.com

Regards

[Phil B.]

Hi guys. I have Canon imagepress c7010vp when I turn on the main switch only standby LED on screen light, if I press power button nothing happened. I tried to check all power supplies it seems ok. Pls I need your help guys what could it be problem I'm ready to pay anyone who shows interest of helping Here is my email tbyabachwezi@gamail.com Regards

what do you mean by: I tried to check all power supplies it seems ok.

HOW did you check them?
did you use a Multi/Ohm Meter?
if so.. what did you check?
incoming/out going power?
do you have a service manual?
ARE you A tech?

Phil B. " The Dentist"

[tbyabachwezi]

what do you mean by: I tried to check all power supplies it seems ok.

HOW did you check them?
did you use a Multi/Ohm Meter?
if so.. what did you check?
incoming/out going power?
do you have a service manual?
ARE you A tech?

Phil B. " The Dentist"

Thank you for replying, yes I'm tech and I used multimeter to check +3v and fuse also I have service manual for the same machine.

[Phil B.]

Thank you for replying, yes I'm tech and I used multimeter to check +3v and fuse also I have service manual for the same machine.

Just 3v? What controls OP?
Motors/Solenoid?
5v ok?

Sent from my SM-G960U using Tapatalk

[zoraldinho]

Turn off all accessories and try again. You know how to read the flashing light on the motherboard?

[tbyabachwezi]

Turn off all accessories and try again. You know how to read the flashing light on the motherboard?

No any flashing lights on accept on main board-M buy it's not flashing it's solid red. Can you pls give me your email then I can call you thought Mobile?

[tbyabachwezi]

[QUOTE=Phil B

On top of that I have checked 5v going to DC controller 1-2 are ok.

[wcanonw]

Turn off all accessories and try again. You know how to read the flashing light on the motherboard?

hello master zoraldinho I have a similar problem with an imagepress canon c6000, pressing the main switch button on the lcd panel, just turn on the main power lamp. when checking the part where the main board is there are some LEDs that are lit orange, but there is no sign that the motors, fans, fuser unit, etc. will be activated. of the printer

[wcanonw]

[QUOTE=tbyabachwezi;748840][QUOTE=Phil B

On top of that I have checked 5v going to DC controller 1-2 are ok.[/QUOTE]

hello how did you solve your problem with the imagepress c7010

[Setright]

Hi !

This is just a suggestion: Check the handles on both fixer units. They must be locked into the correct position. Next, make sure BOTH the high and low voltage switches are being engaged when the handle is locked in place. The switches are at the rear of the machine, you can see them if you remove the rear cover.

I have seen the low voltage switches (microswitch) lose one screw and therefore not close when the handle is locked. This means the controller thinks the fixer is open and it will not switch on the high voltage circuits.