Hi Guys,
It's me again....
I have another problem.
The touch panel loose calibration.
If I wait, calibration return ok, but not all the time.
Have you got any ideas?
Thank's
Stéf
Hi Guys,
It's me again....
I have another problem.
The touch panel loose calibration.
If I wait, calibration return ok, but not all the time.
Have you got any ideas?
Thank's
Stéf
Hi,
Yes I have tried to pulling the op panel and move the connector.
I have only changed the main board.
I have never upgrade the firmware and I don't know how can I do this (I don't have SST and firmware ).
I'm not newbee in IT and electronic ;-)
In Service Mode, I can't use the touch panel because, the left part of the panel is inactive ...
The main problème of this printer was : not used 6 month in humid garage
Informations sur la version
Version carte principale : 7 Version du contrôleur : 9401.7601.6602 Version du scanner : 5201.100 Version du module de finition : 0.0.0.0.0
Type Total 112 : Total (Noir/Grand format) 2431 113 : Total (Noir/Petit format) 46743 122 : Total (Quadrichromie + Monochrome/Grand format) 1059 123 : Total (Quadri + Monochrome/Petit format) 16061 501 : Lecture (Total 1) 28187 301 : Impression (Total 1) 43258
I would try this
FK2-0329-000 1 ANALOG TOUCH PANEL UNIT
First things first.... I'd make sure there is no dust/debris buildup around the edges of the touch panel. That can cause issues.
Second, make sure the copier's network connection is NOT running "Power Over Ethernet"!! This will burn out network cards and control panel CPU's. I've been there....trust me on this!!
After that, reseat all your connections and try calibrating it again. If calibration fails or doesn't hold... THEN replace the touch panel.
Sorry for the long time response, I had broken the flat connecteur of LCD.
I had tried to repair it, but I do somes mistakes, bad day for me ...
So I have buy another panel on ebay for 70£.
Thank's to all
Bookmarks