Dear All,
Refer aforesaid error where I had replaced Laser unit & DC Controller Card of working machine, Still same error occuring ... Any clue or support on priority appreciated.
With warm regards,
Rauf Sayyed
# +91-9324624260
Dear All,
Refer aforesaid error where I had replaced Laser unit & DC Controller Card of working machine, Still same error occuring ... Any clue or support on priority appreciated.
With warm regards,
Rauf Sayyed
# +91-9324624260
Carefully check the continuity from seat of connector to the DC controller board. Chances are there is a bent pin for the connect or a break in the cable connecting to the DC controller board. With a faultless DC Controller and laser, what is left is the link between the two.
Check and make sure the cable that runs from the big side door switch to the laser shutter lever isn’t broken
Sent from my iPad using Tapatalk
Bookmarks