Sorry guys,i 've come across this thread just now;i hope the issue is being solved by now.
If not,i would suggest to replace the 2 RAMS on MNcont 2 pcb at the same time.
One of the RAMS is probably defective such that the image processing is only being done halfway.
Good luck.
The main cont pcb2 is found in the controler box which is situated at the rear of the machine.
In fact there is only one dimm assy(2go or 1.5go).The part no is FM4-0837.
Check your service manual to see how to take out this board from the machine.It goes through a slot on the left hand side of the machine.
Bookmarks