Hi, all
I use the canon IR3100CN. It`s show error code E00070-0001.
Please help me.
Hi, all
I use the canon IR3100CN. It`s show error code E00070-0001.
Please help me.
It's the itb home position sensor.
Need to remove the itb assembly and look for a torn or slipping transfer belt.
Also the roller support arms break on a regular basis which causes the belt to lose tension.
Transfer belt assy. Sits above the drum, normally it gets torn ot tension arms break that keep it tight. Also had issues with white home position patches getting dirty.
Cheers Paul...I gave up after being asked what an Itb was
Being a so called "senior tech" Oze a find that patience is a virtue!!
same with me guys thank you lets me try. but can anybody have the manual of this machine because i want to read how to assemble this machine please help!
I've one IR3180ci. It had it's ITB torn apart. I took it out and replaced with a brand new belt.
I did not use Service Mode (I am not sure if I was suppposed to do any thing on the Service Mode).
Now the belt is on but I get the E000070-02 or E000070-01 error. The 2 page instructions with the ITB stated to perform some key presses in Service Mode, which I did but I always get the NG! Error on Service Mode. The machine turns on, the ITB and the ink rotats, while the screen shows "Printer Warming up" message and then after 1-2 minutes I get the error.
Can you please help.
Both white patchs on ITB inner side are on correct side and they are clean. (I took it out after assembeling it when I found the error could be because of the white patches get dirty).
The ITB home position sensor has a plastic cover part 16 in picture that sits above the belt, has this been
fitted correctly?
Capture.JPG
Bookmarks