Thanks: 0
Likes: 0
Dislikes: 0
Hello...i am installing a used c6010s in a customers office. everything is all connected and comes to ready just fine. Every copy jams over sensor ps200 (just before entering the fuser). I changed the sensor and the transport belts, and the motor. (all looks fine). Just for grins, i also changed the fixer feeder driver. Anyone have any thoughts? I re-seated all the connectors on the DC controllers. Any help would be appreciated.
Originally Posted by mc921
Is it on all paper sizes & from all trays ?
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Correct. 1.2 million copies on the unit. Client bought on ebay...so no p print available.
Maybe a broken wire in that fuser guide assembly, is that sensor in the guide that flips up when clearing a jam? I remember the yellow fuser cover catching the wire loom at the top if not careful putting it in position.
No... ps200 is in the transport assembly going into the fuser. This sensor has no flag.
My bad, that transport assembly kind of sticks out of the machine when the two halves are separated for shipping, could it possibly have been knocked during transport, so it isn't in correct alignment to the fusing station, that might cause the delay jam. Have you tried longer sheets?
yep...tried all paper sizes. The assembly is mounted correctly, the 3 connectors are all intact, with new belts and a new sensor. Physically, all is fine. leaning towards the DC controller 1-1....
0112----xx12 Pre-fixing feed sensor 2
PS200
01xx is a delay jam
you stated ( Every copy jams over sensor ps200 ) wouldn't that be a Stationary Jam 02xx if paper is over sensor ?
Pre-fixing feed driver PCB--check the connectors signals & Harness to and from
I/O
P005
Bit 1= Pre-fixing feed sensor 2
PS200 0: Paper is present
PS200.jpg
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
The pre fixing feed driver was replaced, no change. I will be working on the unit this afternoon...will let you know. Thanks for the help!
0112----xx12 Pre-fixing feed sensor 2
PS200
01xx is a delay jam
you stated ( Every copy jams over sensor ps200 ) wouldn't that be a Stationary Jam 02xx if paper is over sensor ?
Pre-fixing feed driver PCB--check the connectors signals & Harness to and from
I/O
P005
Bit 1= Pre-fixing feed sensor 2
PS200 0: Paper is present
PS200.jpg
first > important to check for change of state in I/O
I/O
P005
Bit 1= Pre-fixing feed sensor 2
PS200 0: Paper is present
need to check all harness connections if no change of state is shown
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Posting Permissions
Reply With Quote
Bookmarks