Thanks:
0
Dislikes:
0
-
IR-ADV400 Developer Issues
Hi All
Got a bit of a curly one
IR-ADV400 that’s got some issues with half toning leaving streaks on A4 Paper / Half-toning
we have changed:
developer - brand new
drum - brand new
t/fer roller in right hand side door - brand new
static eliminator in right hand side door
hv power pack (replaced)
cleaned lasers
cleaned hv contacts in machine, stripped and cleaned laser glass with alcohol / water mix
only affects half tones though and when printing
any idea where to go now as we have replaced a few parts, which has improved issue but not to a great degree.
please see sample below:
D718B54D-F337-475E-8CA5-7F3DA7229F91.jpg
Last edited by shawncrowther; 06-28-2019 at 06:08 AM.
-
Trusted Tech
100+ Posts
- Rep Power
- 24
Re: IR-ADV400 Developer Issues
How does the image look at the drum if you do a forced stop ?
-
Re: IR-ADV400 Developer Issues
I will ask the tech if they did the force stop drum check, I am on the managed helpdesk posting on their behalf but this machine has been a headache
1730 and 400i machines are usually very good BW workhorses, not much goes wrong
This thing is a demon!!
-
Re: IR-ADV400 Developer Issues
Hey all
Issue was toner behind the t/roller in side door
thick crust of toner, cleaned it up, changed t/roller again and all sweet
definitely a tricky one!
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks