Canon IR 3230 No display

[suresh968]

Hi ,

After switching power my Canon IR 3230 No display. Its looks like dead

[Phil B.]

Hi ,

After switching power my Canon IR 3230 No display. Its looks like dead

any lights?
do you hear fans/motors turning?

you ask for help but provide no info for us to help you with

[suresh968]

any lights?
do you hear fans/motors turning?

you ask for help but provide no info for us to help you with

Green Light is On but fans/Motors are not running

[copyman]

Do you mean after "switching power on" or "switching" power supply board?

It's been awhile but think no display has somewthing to do with the HDD or system software. Also think bad or missing ROM would cause this.

POSTERS PLEASE PROVIDE MORE DETAIL IF YOU WANT HELP !!!!

[Deepaklohmi]

i have same problam with ir3230 after RTC jp1 reset machine gets start but after 1 minut everythings goes off
pls help what to do now Green light is still on

Recovery procedure done Turn off the main power switch and short out across the 2 contacts [A] of JP1 on the main controller PCB for
approx. 1 second using a conductor wire or other.
(This will reset the register value to the default.)


pls help

[Buenor]

For me it looks like LVPS or HVPS issue.
Try minimal configuration or with opened all doors (this will cut off all bigger electrical circuits). Better is to remove fuser, ITB, drums, devs.
This way you eliminate any short circuit in consumables or grounding problem.

[Deepaklohmi]

For me it looks like LVPS or HVPS issue.
Try minimal configuration or with opened all doors (this will cut off all bigger electrical circuits). Better is to remove fuser, ITB, drums, devs.
This way you eliminate any short circuit in consumables or grounding problem.

Nothing happens with minimum circuits connected no fuser no drawer no develper unit no adf connected

[Buenor]

So next step I will do is measuring a voltage on connectors. If you have a service manual you can check a correct values. Lastly, do you have any other working machine? It is possible to exchange a boards and power supplies between them. It is good practice to put suspended logic boards like main controller, drum drive into. into working machine. Opposite with a power supplies - working PS to the suspended machine.
First, Very important, do not exchange main controller with additional boards on it, like serial and counters board. Them must stay in original chassis. Second, do not exchange more than one board at same time! Change one and check the machine.
If you need and want, I will search a voltage values and connectors to check for you, but tomorrow

[Deepaklohmi]

So next step I will do is measuring a voltage on connectors. If you have a service manual you can check a correct values. Lastly, do you have any other working machine? It is possible to exchange a boards and power supplies between them. It is good practice to put suspended logic boards like main controller, drum drive into. into working machine. Opposite with a power supplies - working PS to the suspended machine.
First, Very important, do not exchange main controller with additional boards on it, like serial and counters board. Them must stay in original chassis. Second, do not exchange more than one board at same time! Change one and check the machine.
If you need and want, I will search a voltage values and connectors to check for you, but tomorrow

Thanks a lot

[Buenor]

Checklist:

1. Is 12 V output from theMain Controller PCBJ3?
2. Is 12 V supplied to theMain Controller PCBJ22?
3. Is 12 V output from theLowVoltage Power SupplyPCB J812?
4. IS AC supplied tothe AC Driver PCB J6010?