105 Slow printing with error message

[davidj7]

Hi, One of my 105 is printing very slowly and in the System Monitor, Status Window while printing ,intermittently it shows error.. and continues printing after a few seconds.I have changed the IP Board,MFC ,DC Board and Power Supply Board. any suggestions grealt appreciated... While copying also the same problem exists.
any ideas ...

[faisal jilani]

replace exp lamp only

[davidj7]

How is exposure lamp related to this problem?

[faisal jilani]

chak lut 1 and 2 if caming n g this meen exp lamp is week.fanction>adj>lut if ok this meen exp lamp is good.

[davidj7]

I dont have a copy quality issue, rest assured the lamp is fine, I get good quality results in both copy and print.If this is an issue with the lamp then there would be no issue in printing

[Kopyrtek]

Does it show an error in the history?Also do a HDD check and clear HDD and reload system software.

[davidj7]

There is no error in history, I have completly replaced the MFC which includes the Hard Disk ,RAM etc

[faisal jilani]

i now copy is caming good you chak lamp if both sides are black replace it.i change to many time lamp for this problam.if ok replay it.

[nivssluck]

just try what faisal jilani said

[20YRSEXP]

In service mode copier>options>body>FDW_DLV=1
and ACC_COIN=0
Check those settings