Image fault.

[SCREWTAPE]

I got this CLC 5100 that has this image formation problem.
Everything for the image formation area has been change, laser's,
video controller PCB.

[alex@wocltd.com]

just pointing out the obvious - but if you stop the machine in process whats the image like on the itb?

[Oze]

If it's like other CLC there's no ITB...just a transfer drum

[alex@wocltd.com]

i think the clc5100 is a reincarnation of the (horrible)clc1000 - over here is was the 1000,1000s,4000,5000 and then 5100 and it is a pig to work on......

[SCREWTAPE]

The image transfers to paper and not the transfer belt and there is no transfer drum in this one that's the CLC1100 series.

[roho]

what do your pg 5s look like? Seems that the image fault is more with k and m. I once had a transfer selenoid lock up from starter- every colour after the transfer in question was affected. Also I found that the corona assemblies before the fuser can cause many image faults as well, as they often get caked badly.

[THUK]

HI,is it the same in single colours.cancel out process units.copying or printing.

[ReproKev]

Try swapping Magenta and Cyan primary corona's and transfer blades to see if problem moves to Cyan.

[555]

do the fuser rollers have ripples on them

[SCREWTAPE]

All drums,blades,primary,grids,developer have been replaced.
I've tried putting the whole laser ass'y from a working CLC and I
get E61 and E100. Here is a PG5. Fuser section is fine.