tears in film of fixation

[AIT MAMEUR]

hi, every one.
i've a problem with my ir3300, i haved e007, i replace the film but the film tears and go to one side of the unit of fixation. i'm in my seonc film and it's the same thing.
please help me.

[Kapten]

Check Nip in servicemode.
If the pressure is wrong you kan se it on the test.
Adjust fixpressure so its equal on both sides.
The lower roller could be defekt so try change that one too.
But the Nip check is important in this case..

In worst case it could be the fix assy that is skew.
Or something in the cheramical heatingelement.
Then you have to be like my colleges, they always change assy.
Ther life is simple..

He he

[Oze]

Change the pressure roller and the bushings.
The film running off to one side will happen if you change the film and not the pressure roller at the same time.

[davidj7]

i agree with oze, check pressure roller. Are you using OEM film or Canon Film. I have seen lots of OEM film which goes in under 100 copies/prints.

[maks]

in my case wherein ordering parts takes a long time to arrive..what i did is to clean also the cleaning roleer...scraping the toner carefully that got stuck on it...then i use a very fine sandpaper to polish it...after checking the lower roller

[fireater]

lemme ask u techs a question.. we all know that the film is cheap and you usually can get it to work with a new one..... but a whole installs in minutes you are in and out of the customers office in minutes.. you know it will work the first time .... no expensive recalls..... why take the chance? REPLACE the ASSEMBLY

[hachetman]

lemme ask u techs a question.. we all know that the film is cheap and you usually can get it to work with a new one..... but a whole installs in minutes you are in and out of the customers office in minutes.. you know it will work the first time .... no expensive recalls..... why take the chance? REPLACE the ASSEMBLY

Well the only reason to change the film is the cost, maybe $10 for the film verus a couple hundred for the whole assy, but the last time I checked the cost for a tech to walk thur your front door was around $100 and the amount of time it takes to swap the whole assy the paper work takes longer to fill out but in todays mind set is how much do you save on your buget is more important than say cust. up time and relibilty
oh how I long for the good old days when qualty was the word not quanity

have a good day

[davidj7]

In my country its the other way round, tech's are cheap , spares are costly. A film would costs $20 and a tech would be around $5. See the diffrence.Any one want to work here? ha

[gaurang_chaudhari]

send me ur email

[AIT MAMEUR]

this is my email : anadjia@gmail.com