ir2200

[bomberi]

thank you for answers. Ihav done all this ways, I have formating the hdd, now i am the step to download the system and when i begen to download there are some error when data is beeing transfered but when i take the boot to transfer it go well and the system is the first to be transfered one by one. I try at least 5 hdd and i have the same error. GOOD

[D_L_P]

I doubt 5 HD would be bad. Sounds like it might be your computer. Uninstall SST and reinstall it. Re download the 2200 system software and go from there.
Or if you have access try another laptop to flash that 2200.

[ymmtech]

You may try alternative way, check HDD SMART status, ... analyze HDD, and/or clone a good image to HHD so to filter out problem of interface between PC and copier.

[bomberi]

I always think about solution, so help is nessessary. Because I have 4 ir2200, 3300 with same error of hdd. I ve taking another hhd with is good and i try to download and it do the same error the system can not download but i win to format the hdd. Ithink that the system is not good. The file is 1,5 MO

[SCREWTAPE]

Hopefully you using a parallel Cable-(Bi Centronics 1284) Or a Canon USB parallel cable. Two, the best advice so far is to uninstalled SST and try using SST v3.11 or v3.22.

[Gerhard]

Are you formating the hard drive using SST. Are you using nethawk(USB to parelel) cable. Nethawk cable needs to be installed (Software) on your computer. not just a cable.

Regards

[bomberi]

I use parallel cable now i want to now if my system capacity 1,5mo is ok. So i want to be sure that the system is good. THANKS

[bnmand]

	Quote:			Originally Posted by bomberi
	I use parallel cable now i want to now if my system capacity 1,5mo is ok. So i want to be sure that the system is good. THANKS

Are you using a IEEE1284 bi-centronics cable hooked up to a parallel port set to ECP mode or using a nethawk (special Canon usb-to-parallel cable).

[bomberi]

Thank you; can i know how to set the ecp mode. i use bicentronic cable and the sst show that. The thing i don't undestand, is why have i succes to format the hdd or when i try to download the boot it go well? Is this possible when the cable config is failled? The system to download first can not go when i take one by one but if a take the boot, or the rui to download they go well at the end the machine show that data is writting now don't cut power. The machine error is E602-01. After succed to format the hdd, the error became E602-02.

[ymmtech]

Can not change to ECP mode if under windows XP. I use a low speed mode parallel. But still ok.