ir2200

bomberi · 10-11-2009

thanks for all help,some week ago i am back to continue my thread for install sst. My problem is the hd and i have adapt a toshiba hd. I have format it with the hd format and its ok. Now if I want to download the system it go well and the machin make downloading in the screen, after a mn it make error: the check sun did not match, the data may have suffered loss/damage while beeing transmitted, check the conexion between the pc and the machin. I try again and it make swithing to the ecp mode has failled. So I want help good.

TCA TECH · 10-12-2009

Have you for matted the hard drive with the correct format tool, open up for mat tool with editor and see if your hard drive type is in there.

mrfixit51 · 10-12-2009

	Quote:			Originally Posted by TCA TECH
	Have you for matted the hard drive with the correct format tool, open up for mat tool with editor and see if your hard drive type is in there.

He claimed that the format procedure went ok,, which means the drive he used had to have been in the table of drives, or the format procedure would not have come back with an O.K. My question for him is,, did you use a NEW hard drive, or a used one? Bad sectors on a hard drive do not show up under HDFormatting, that only writes the partition table and FAT to the hard drive. sounds like a bad drive to me, or bad data from the laptop. Try reloading the system software to the laptop to test that theory.

bomberi · 10-13-2009

thank 4u, my hdd is a new( toshiba mk4026gax). I've traying to reinstall the sst and begin the way, the same error appear now i want to change a laptop to try again.

binks24 · 10-13-2009

Changing the laptop perhaps seems like the wrong way to take, but I´ve actually experienced something like this myself, and after 2 weeks, I took my partners laptop, and it worked fine. There must have been something wrong with the parallell port on my laptop, upgrading using a network cable was never a problem. So try using another computer!

bomberi · 4 Weeks Ago

hello! Iwait always for help;I have cange pc and the sst but always the same error is hear I think it is the system so if someone can send me I will try again.

bomberi · 3 Weeks Ago

Please i want sst old version 1.41 if someone can send me it. My thanks

D_L_P · 3 Weeks Ago

There was a way to workaround formattimg the non-canon approved HD with a newer version if SST.
I'll look for the instructions but, basically you open C:\ServTool\iR2200\HDFormat\XXxxv0013\ir2200XXXX.i ft file with notepad. Get the serial # off your HDD label and add it to the .ift file.
The instructions had specifically which # from the HDD and exactly where to add it to the .ift file, which I'll post when I find it. Or,I might even be able to find an old disc with the ver1.14 SST.