Thanks:
0
Likes:
0
Dislikes:
0
-
iR7095 load paper
had a problem with drawers saying load paper during a run and then it would start up and stop again saying load paper from any paper drawer, did dcon clr and now all drawers say load paper all the time even if full. Did op-sens and now #2 sees paper and no others (op-sens was done with paper in drawers per service manual)...about to do hd format and reload sys software.
anyone else seen this?
-
hd format and ss no good, trying dc controller next
-
If it were just 1 drawer I'd say check the connectors. But since it's all of them, and the DC-CON clear changed your symptoms, I think I'd try DC controller too.
-
well, the dc controller got my paper levels back...but now if i try to run a copy it shows 0214 jams no matter what drawer it is pulling from except #2 works fine still but the paper never gets out of the pu assys. Must be the #1 pu assy i think i'll try it next. either a shot in the pu assy or a bare wire running in the back of the machine from that pu assy. Fun times!
-
-
I replaced the right deck pu assy and that fixed that problem
maybe a short in the pu assy caused the dc controller problem???
Everything is working as it should now.
-
Good job. Thanks for letting us know.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks