Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
I am attempting a Maxtor 6E040L0, 40g.
Is it ok?
Thanks
On the 3200/3220 series you can get into the (IFT) and put that Maxtor serial number in that file. If you need instructions just do a search for it in this forum.
Accidents don't just happen. They must be carelessly planned.
Hi Guys,
I have this CLC 3200 which is coming up with an error E000602-0901, and is pointing to the HDD.
I really don't know what to do.... Please help me....!!!!
Regards.
------------------------------------------
if you are not a tech familiar with SST & Printer Firmware , Call for Canon Service
E602 is a Hard Drive Failure//
in your case -DOSDEV5= Reserved= E602-0901
0901 is = The partition DOSDEV5 is faulty.>
Device error: sector, write/abort, other HDD access (driver) error
it may be possible to recover using the machine's service mode, Copier/Function/System/Chk-Type, setting it to clear a certain partition number, then selecting Copier/Function/System/HD-Clear. After selecting the hard drive partition to clear (setting Chk-Type) and selecting HD-Clear and pressing OK, it will be necessary to turn the copier/printer main switch off then on again.
Once the power is cycled the hard drive will begin to rebuild the partition selected and will take an extra minute or two to come to ready.
* For fault: xx09 use Chk-Type 5
u cal also try this> power off printer> hold down 1 & 9 key, while holding keys, power up printer, hold keys down until u see the white blocks dropping (this is a DEFRAG of HDD) , takes about 30min.
u may get lucky / if not u will need a new HDD & a format of HDD inside printer, then load Printer Firmware all within the Canin SST Program
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Hi guys.
my CLC 3200 is popping up an error code E000602-0901 after booting....
I need to format the hdd....
Please I need help.....!!!
Did u try what I posted
try this> power off printer> hold down 1 & 9 key, while holding keys, power up printer, hold keys down until u see the white blocks dropping (this is a DEFRAG of HDD) , takes about 30min.
if HDD is bad or going bad u can only format it while inside printer using SST & trying to reload printers firmware/
when installing a new or refurbished HDD > U still need SST & Printer Firmware using the firmwares Format file
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Thanks Teckat...
I did try what you told me... and I saw the white blocks dropping and waited for it to full the screen.. and after that.. I just saw download mode.... on the screen while I was still holding down 1 & 9 button.... and northing happened.. please advice... what am I suppose to do next whn I see download mode...?
Bookmarks