mama mia'
You can say that again...
Semi-Success...Got the Rom flashed, and SST is asking if HDD was replaced, and goes to initialize and reports:
Error response:Process has ended in error.
<<< FileName >>>
HDDFormatALL:C:\ServTool\iRXXXX\HDFormat\XXxxv0011 \iRXXXX-XXxx0011-HDFormat.ift
Module : SendFile() - 5
E240...
Possible wrong HDD? Here's the HDD info:
Old HDD
Hitachi Travelstar model HTS541020G9AT00
20GB ATA / IDE 5400RPM
P/N: 13G1581
New HDD
Hitachi Travelstar model HTS540040M9At00
40GB ATA/IDE 5400 RPM
I bought the exact same drive, but...who knows? Will this drive work?
First off that E240 is a Boot Rom error/ remove n' clean contacts/ re seat/ or replace it
WM2-5216-000/or FK2-4907-000 is that the part # u used ???
**** 20GB is the standard in this model/ think u can expand memory - but not HDD
on a new HDD u have to format first/ then update Boot Rom
I had to update the Boot Rom before I could upgrade the HDD...now I have version 11. something...
Where is the boot rom?
Unfortunately, I ARE the qualified tech on this job.
No matter, the issue was resolved; I cloned the old drive and burned the image on a drive NOT on the list of approved drives. Seems to work perfectly fine.
I have sst and firmware ir 3570 UsenV4003, but i not found HDformat in list, help me solution that, I look single not found too in list
Firmware is listed under 2270 under connect-
look in this path on your laptop> u should see a folder IRXXX --in there is th Format folder
C:\Canon File Folder\SST System Software Folder\SST Files\iR2270_v40.03.02
if u don't see it u need to re-register the firmware-
remember on this series> the SST MUST SEE YOUR HDD> either a Canon OEM part or similar to what u removed>
the iRXXXX-XXxx0011-HDFormat.ift file is encrypted & not visible ,so u cannot Modify the HDD Descriptor
for other non-OEM HDD's
READ PDF.>>>SST HDD Not Found.pdf
2270.JPG
Last edited by teckat; 06-29-2012 at 03:23 PM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks