Originally Posted by
Machine Cycle
As you mentioned It had a IKON Fiery box,D8Y1F. Now as far as the way this is to be cabled the connection on the side it has two ports and one I see is a "network" and the other is an icon of a "printer" how would the cabling be set up for the Fiery to the main copier and them the a Router to the side next to the parallel connection? On the very bottom of the console (operator screen panel) it has a Warning triangle with the caption "check the Network connections".When I followed the menu to the picture of the copier to the left it had two areas Scanner then below it Printer.with nothing in them.
I followed the other route....the left-facing head with the "star' symbol (pressed) to the "select system setup,then Network setup..pressed tat which lead me to "TCP/IP settings...I pressed that which sent me to a new menu SNTP Settings or Use PASV Mod for FTP.....On or Off?
Is this the correct path to install the TCP/IP,Sub mask,Gateway,ect?
And if I had the Network Quick start guide, it would more than likely tell me were to install the CAT 5/ether net cable from one point to another. As well as CDs (Remote UI Guide,Network Guide,Color NetWork ScanGear User's Guide,PS/PCL/UFR Printer Guide,PCL Guide,PS Driver Guide,UFR Driver Guide.....Probably would be able to down load some of them, but maybe not Network Guide. ...
As far as being able to set up the TCP/IP would any of what I explained to you be "on the right path"? Were to next....Thanks for your help,Steve
Bookmarks