Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Page 3 of 3 FirstFirst 123
Results 21 to 24 of 24
  1. #21
    Service Manager 10,000+ Posts
    iR C3220 full auto gradation adjustment problem

    teckat's Avatar
    Join Date
    Jan 2010
    Location
    VA
    Posts
    16,106
    Rep Power
    244
    on your PG10 do u have a non image area on all four sides
    have u tried to calibrate with either a 11x17 / & Ltr-r size

  2. #22
    Service Manager 10,000+ Posts
    iR C3220 full auto gradation adjustment problem

    teckat's Avatar
    Join Date
    Jan 2010
    Location
    VA
    Posts
    16,106
    Rep Power
    244
    Quote Originally Posted by sgcopiertech View Post
    I will keep you posted, thanks for the suggestions



    yes lamp is ok and moving
    the machine doesn't have image pass.





    well, I've got experienced on this machine where as when checking the laser it says ok
    but ends up being the the culprit, so I was just wondering if it's the same case with the
    CCD or Reader PCB.

    PG6 alignment is ok

    (problem machine) auto gradation test print alignment compared with (ok machine) auto gradation test print is also ok.

    thanks again!

    also what about that copyboard cover switch/sensor/that reads paper size for prints and auto gradation/ sends to CCD for original detection position


    if u make copies off the glass/and did a CCD adjust/ your Reader n' CCD are ok

  3. #23
    Field Supervisor 500+ Posts smiley's Avatar
    Join Date
    Aug 2008
    Location
    manila
    Posts
    601
    Rep Power
    38
    on pg 10 you can also see if there is a displacemant,if there are colors that overlap the other color or if there is a blank area between any of those color.and you can see it at the 1st testprint of the auto grad.each color should have aligned equaly at the leading edge.
    there is no glory without sacrifice

  4. #24
    sgcopiertech
    Guest
    quick update:

    PG10 print is ok no displacement

    Quote Originally Posted by teckat View Post

    also what about that copyboard cover switch/sensor/that reads paper size for prints and auto gradation/ sends to CCD for original detection position
    do you mean, the original size sensor?
    paper size detection ok.

    I changed the reader controller PCB

    but still same problem.

    I can't concentrate on the machine too much.
    still need to do a lot of orders.

    I'll put it one side first but will still post the solution (hoping can still solve)
    once I'm free.

    thanks!

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here