IR C5180 help! Functions Limited?

[SCREWTAPE]

You also have these at the bottom.
Not sure if you checked those at the bottom.

[pacman]

Yep, I definitely hear a clicking sound. I'll check the switch when our tech comes in either tomorrow or next week

EDIT - yep, checked those too. They move just fine.

[SCREWTAPE]

Then my guess would be to check that finisher controller pcb. Check all fuses for continuity.

[teckat]

Not today....I've been on conference calls all day. I think we've tracked it down to the flag issues you posted OR the lift motors. When we turn the machine on, the finisher trays do not move, so we figure it's one of those 2 issues.

EDIT - The flags seem to be fine though. Pretty loose and free flowing if that makes any sense.

how do u have your A & B Tray set up> on prints/copies ?? a good test is to set up tray B FOR COPIES ONLY/ SET UP TRAY for Prints only
power off printer / run a glass copy see if tray B moves up to accept copy !! if it goes down ,sensor arm may look good but it is blocking interior sensor. if there is no movement / check that molex connector

+ Check that grey square molex connector it supplies power for finisher it goes in to lower cassette pedestal, i think it has two screws to open, check the two small connectors inside/ both must be seated firmly