You also have these at the bottom.
Not sure if you checked those at the bottom.
You also have these at the bottom.
Not sure if you checked those at the bottom.
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
Yep, I definitely hear a clicking sound. I'll check the switch when our tech comes in either tomorrow or next week
EDIT - yep, checked those too. They move just fine.
Then my guess would be to check that finisher controller pcb. Check all fuses for continuity.
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
how do u have your A & B Tray set up> on prints/copies ?? a good test is to set up tray B FOR COPIES ONLY/ SET UP TRAY for Prints only
power off printer / run a glass copy see if tray B moves up to accept copy !! if it goes down ,sensor arm may look good but it is blocking interior sensor. if there is no movement / check that molex connector
+ Check that grey square molex connector it supplies power for finisher it goes in to lower cassette pedestal, i think it has two screws to open, check the two small connectors inside/ both must be seated firmly
Bookmarks