Hi,
I am upgrading a ir2830 to print/scan, hdd and am in need of sys. software-firmware.
Thanks very much in advance.
tsb13
abex1@knology.net
Hi,
I am upgrading a ir2830 to print/scan, hdd and am in need of sys. software-firmware.
Thanks very much in advance.
tsb13
abex1@knology.net
Thanks again teckat,
After format and installation, all whith out any problems , machine comes up with E602-002. Reinstalled again..same issue. Any info on this would be greatly appreciated.
Thanks in advance. 2230hd
tsb13
In service mode Copier / Function / System & select HD-CHECK followed by pressing OK key. This check will count backward from 99% & run for approx. 10 minutes . The results of HD-CHECK will be displayed in LCD
1. OK
2. NG { hardware } may need new HD, try HD format 1st.
3. NG { software } restored / alternative sector } is displayed. Will need to install new system software.
When HD-CHECK is complete run HD-CLEAR in service mode Copier / Function / System then select HD-Clear followed by the OK key. HD-CLEAR will initialize the partition specified by CHK-TYPE. Once complete you will need to re-boot machine. After clearing the HD the boot process will take longer then return to normal.
Well,
Cant seem to get it in service mode. tried many times, any suggestions? Please? lol
Thanks
tsb13
E602-0002 - A HD data read error was detected when the HD was started up.
Cannot find the System File Using the Service Support Tool [SST], perform HD
FORMAT [Equivalent to High Level Format].
Make sure when u added the New HD-FORMAT Ver. in SST under ir2830/ that u deleted the old HDD-Format ver.
To perform HD Format, perform the following:
1. Enter Download Mode by holding 2&8 and powering ON.
2. Start Service Tool and perform HD Format first
then
3. Reinstall System Software, RUI, & Language.
First make sure that u have only one version of the SST on Laptop/ was 2830 HDD ok before Error code/
what were attempting to do in the first place ??
Machine did not have a hdd or print. I am attempting to upgrade for cust. I got the hdd from mem. experts model specific.
I will follow you inst. and see if i screwed up before.......Thanks!
No luck,
Guess it would help to have the install instructions or svc. manual. I have run format (all) O:K, installed sys.,lang. rui, boot. (says its already there) still i overwrote it. goes through all items fine ,restart machine goes through writing to hdd then shuts off to restart and then E602-002. I must be doing something wrong or not in sequence.
Sorry to keep bothering you. Thanks very much.
tsb13
I need IR3530 firmware
Urgent.
email: rajacs41@gmail.com
thanks.
Bookmarks