I get RemoteUI Contents is Not Found!! RUI Module Version : 4303 error even tough this option is turned on on the system settings of the printer.
Do i need SST and firmware to and re-install?
Cheers
I get RemoteUI Contents is Not Found!! RUI Module Version : 4303 error even tough this option is turned on on the system settings of the printer.
Do i need SST and firmware to and re-install?
Cheers
Yes, you could probably get away with just reinstalling the RUI with SST
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
is it cheeky to ask for someone to help me out with sourcing SST? email: giovil38@gmail.com or PM me pls...i hope i don't open a big can of worms!
Do u know how to use the SST TOOL ???
U need SST and 3100CN Firmware
The correct version of RUI firmware must be flashed onto the copier. A specific version of the RUI firmware is required for each individual version of system software (MN-CONT Firmware) for each specific copier model. The correct version of the RUI firmware to be used with your current version of MN-CONT software can be found on that system software version's System Software CD.
To correct this problem:
1. Flash the copier with the correct version of RUI firmware.
2. Be sure to enable HTTP and RUI on the copier.
3. Be sure to enable "Dedicated Port" on the copier.
NOTE: For MEAP Enabled Devices, please make sure that the proper MEAP version in Service Mode/Copier/Display/Version is also installed. If everything fails, perform a Clear MMI. Also note that on MEAP enabled devices, USE HTTP under TCP/IP Settings and USE HTTP under MEAP Settings must be ON.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Before you try all of that try clearing your temporary internet files and such. I have seen on a few occasions when replacing machines the temp files must be cleared before i can connect to the RUI on the new machine.
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
I have seen that exact error a few times where i have replaced an old machine and put the same IP address on a new machine and then try to access the RUI on the new machine. It will connect but errors when pulling the temp files from IE.
The RUI firmware must be flashed onto the copier/ end of story
the-end1..jpg
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Patch cable....done
SST V3.21E...done
Firmware......for everything else there is mastercard!
Bookmarks