hi guys
I got a 3570 with C bootrom
when i plug in an N bootrom + HDD
I got this e744-3030
checked the manual, but got no info on the "3030"
any info?
thanks
hi guys
I got a 3570 with C bootrom
when i plug in an N bootrom + HDD
I got this e744-3030
checked the manual, but got no info on the "3030"
any info?
thanks
Enter service mode to check the amount of RAM recognized by the machine.
COPIER>DISPLAY>ACC-STS>RAM
The machine should display 512MB of RAM installed.
imageRUNNER 3570 SKV00001 ~ SKV62419
For manufacturing convenience, the DIMM configuration has been changed from using 2x256MB memory
DIMMs (WA73296-000) to 1x512 MB memory DIMM (WA7-4625-000).
When replacing a DIMM, use (Qty 1) 512MB DIMM or (Qty 2) 256MB DIMM. The 256MB DIMM will
continue to be supplied.
Be careful not to install a 512MB DIMM into a machine with 512MB already installed. Adding 128MB,
256MB, or 512MB DIMM into the additional open slot will render the machine inoperative.
The 512MB DIMM can be mounted on either of the slots.
The additional 256 Memory DIMM is no longer provided in the Multi-PDL Printer Kit.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
case closed
add 1 256mb
thanks peter for quick reply
thanks teckat for the wonderful and very useful info
welcome~~~~~~~~~~
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Hello everyone,
I have the same problem like this. My bootrom ver 08.38 and ver 06.36 with the pair 256 of RAM, but the machine not functioning its still E744-3030. I still cannot upgrade the machine.
The E744-3030 -- can be caused by an insufficient or damaged RAM installed in the machine. Enter service mode to check the amount of RAM recognized by the machine.
COPIER>DISPLAY>ACC-STS>RAM
The machine should display 512MB of RAM installed.
*NOTE Some machines will have 2x256MB SDRAM DIMMs installed and some will have 1x512MB SDRAM DIMM installed.
remove>clean ends> re-seat/ or swap to check
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
U have old BOOT ver.
Latest Firmware-----------imageRUNNER 2270/2870/3570/4570
05-10-12
System Software v41.01.01
BootROM v11.43
Language v41.01 (JEFIG)*
RUI v38.01
re-flash your BOOT ROM / Or have a service person update firmware with SST
imageRUNNER 2270/2870/3570/4570
Copier Boot ROM Part Number=FM2-4837-000
The Boot Rom slot on the Main Controller is the same size as the DCON Dimm slot on the DC Controller. Hastily replacing this chip without confirming the correct slot will damage the chip. NOTE: If you are installing a network boot rom and it is damaged, you will need to contact the TSC for the replacement procedure.
E733-2.jpg
E733.jpg
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks