IRC3200

[linuxxpwin]

Good Morning

I am in need of Canon IRc3200 service manual with dadf especially the dadf part of the manual.


thanks guys


Linuxxpwin

[linuxxpwin]

My DADF Is receiving power but I need to troubleshoot, if the circuit diagram is available, I would be greatful.



Linuxxpwin

[SCREWTAPE]

Its receiving power... But what is it not doing?

[linuxxpwin]

just sits there no lights on pcb, movement by motor. service manual with circuit diagram will do the trick for me, for the Dadf.

[teckat]

just sits there no lights on pcb, movement by motor. service manual with circuit diagram will do the trick for me, for the Dadf.

no lights on pcb/ u mean DADF pcb ???/

push CB1 in on DADF pcb

turn off 3200/pull out dadf power cord/pull out dadf interface cable/ re attach cable & cord/ turn on 3200/
report back

Power supply

The power supply for this unit is supplied by the copier’s two 24V systems.
System 1 (J2): Supplies loads after passing the circuit breaker (CB1).
The circuit breaker protects the circuitry by shutting off the power supply
if an over-current is detected.
System 2 (J1F): Converted to 5V by the regulator (Q17) and then used for logic systems
and sensors.
Fuse resistors (FU1 and FU2) protect the circuitry by blowing to shut off the power supply
if an over-current is detected.

click on pics below

dadf..JPG
dadf2..JPG
dadf3..JPG
dadf4..JPG

[SCREWTAPE]

When you stand in front of the machine. There's a little black button type switch that's on the right rear end of the feeder next to the hinge. If the height is high on the right rear end, where that switch is at ,the feeder will just act dead. Make sure that when the doc feeder is in lower down position, check that the switch is making contact against the machine.

[linuxxpwin]

all of the above mentioned routines and observation I have done already, it was working before but it just stopped the rest of the machine is fine.

If I can get the manual especially with circuit diagram I am good.

IRC3200 service and Parts with Dadf.

[linuxxpwin]

I tried to read the pics here I am unable to do so, I maximize and minimize, fit to page print as is magnified but I am unable to read diagrams.

I think the manual will do just fine.

Linuxxpwin

[linuxxpwin]

teckat please check PM.

[linuxxpwin]

I have located the service manual and parts manual but the DADF service and parts is not included in the manual. please send urgent if u can. if not I understand.


Linuxxpwin