iR7105 Punch Issues

[teckat]

Hi,

Anyone got info on what the dip switches should be set to on English 4 hole punch or Swedish 4 hole punch?

Thanks,

Shazza

turn all off before setting dips/ turn on finisher then machine in that order/ set punch operation & check

SW381 in Finisher
Dip position = on is up/off is down
punch unit not used= all dips off
2-hole punch-#1 on/ rest all off
2-/3 hole punch-#2 on/ rest all off
4 hole FRENCH punch used- #3 on/ rest all off
4 hole SWEDEN punch used- #1 & #2 on/ rest all off


SW381 DIPS are below the SW382 DIPS

[shazza]

Thanks Appreciated.


Regards,

Shazza

[teckat]

Thumbs up..jpg

[MrB]

Thanks to the both of you (Shazza & Teckat)
FIXED IT
Was set with switches 2+3
Turned off 2
And now fully working
Think the tech who upgraded it didn't know what he was doing lol

[teckat]

Thanks to the both of you (Shazza & Teckat)
FIXED IT
Was set with switches 2+3
Turned off 2
And now fully working
Think the tech who upgraded it didn't know what he was doing lol

HatTip_2..jpg
Welcome

[shazza]

Hi,

Plot thickens now! It has recalled on last Tech and is now misalignment of 4 hole punch. First one is fine then all 4 are misaligned getting worse from top to bottom.

Stripped hole punch unit X1 and went through set ups no Joy.

Thanks,

Shazza

[teckat]

Hi,

Plot thickens now! It has recalled on last Tech and is now misalignment of 4 hole punch. First one is fine then all 4 are misaligned getting worse from top to bottom.

Stripped hole punch unit X1 and went through set ups no Joy.

Thanks,

Shazza

are u talking about same punch unit / what is a X1 PUNCHER ???

u mean the internal V1 for 7105

[shazza]

Hi ,

Sorry yes Internal W1 French 4 hole punch.


Shazza

[teckat]

Hi ,

Sorry yes Internal W1 French 4 hole punch.


Shazza

Go in service mode to test the Finisher-V1 M24 Internal Punch Unit-V1 punch motor and move the slider assembly.


Use the following procedure to rotate the M24 punch motor and punch slider movement.

Note: The front door interlock must be actuated for this test mode to work

1) Power off the finisher
2) Place the DIP switch SW382 to these settings

3) Power on the finisher (Note: To test the finisher it is not necessary to power on the copier)
4) Press switch SW385 to enter the service mode
5) Press switch SW383 repeatedly to move the slider back and forth to the rear position
6) Press switch SW384 repeatedly to move the slider back and forth to the front position
7) Press switch SW385 to exit service mode
8) Power off the finisher and reset DIP switch SW382 to the original setting



ADJUSTING PAPER STOP POSITION BELOW/ CLICK ON PIC

V1..JPG
5.Will cause machine execute punching/ machine will stop paper without switching it back/punching will take place.

[teckat]

Hi ,

Sorry yes Internal W1 French 4 hole punch.


Shazza

ADJUSTING THE PAPER STOP POSITION/ DOUBLE CLICK ON PIC BELOW

V1..JPG
5. Will cause machine to execute punching/will stop paper without switching back/punching will take place.