Hi Teckat,
I have gone through all those set ups you suggested and it's fine when you do a single page hole punch job but when you do 10 + multiple copies it skews big time.
Regards, Aron
o
o
0
0
Hi Teckat,
I have gone through all those set ups you suggested and it's fine when you do a single page hole punch job but when you do 10 + multiple copies it skews big time.
Regards, Aron
o
o
0
0
Hi,
The image is not skewed just the punched wholes at punch unit. at some stage? Its ok on a single sheet but skews on multiples so must be a didfernt paper path back into punch unit.
I am going back Tomorrow to investigate . I have benn told to remove mylars on metal baffle unit A1.
Sorry but have not got a copy of skew punch.
Will get one and post Toms.
Thanks
I did not mean on the image/
I meant/ if the paper was skewing to cause the punched holes to skew
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Just to add another thing to check. Try running jobs from a different drawer. I had a 7105 where the holes were wandering around on the page. If I ran the job from deck 2 the holes were dead on as if I used a drill press, from deck 1 you could barely see through the stack. Replaced the tires in deck 1 and holes were perfect again.
Hi,
Replaced the Punch unit complete and all ok now no skew but customer wanted holes to match with dividers. Went through the set up routine with dip switches that were posted all ok on test run 1 Copy. Come out of diag mode and back to normal!! not skewed but to far to the right 20 mm to right hand side.
Any other ideas.
Regard,
shazza
Bookmarks