Screw thanks let me find the coronaOriginally Posted by SCREWTAPE
Thanks: 0
Likes: 0
Dislikes: 0
Screw thanks let me find the corona
First at all, make sure, that the atr and the patch sensor is clean
If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions!
okey Herman
First at all, make sure, that the atr and the patch sensor is clean
good point, but machine goes in Error 2/3 seconds after turn on /too soon to involve patch sensor
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Not after 2/3 sec after turn on. When I turn on machine start to warm up when finish it start to enter into gradation process when it is in that process it start to rotate the whole mechanism I think its 3, 4 seconds then it stuck
SORRY FOR MY ENGLISH I AM TANZANIA from E.Afrika
no problem, your english is fine, at least for me
If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions!
do u know how to remove ATR and Drum ?
imageRUNNER C6800 / 5800 / 6870U / 5870U / 5068 / 5058
ATR Sensor Shutter =The shutter is illustrated below.
ATR Shutter is-= FC5-2577-000.
ATR Sensor Unit -= FM2-0422-000
Patch Image Read Sensor (PS2) =FH7-7601-000.
Last edited by teckat; 08-12-2010 at 12:17 AM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
samsogoye:
Take off the front cover and see if the drum is turning> if not
Check if the screw is broken on the drum shaft in the back of the machine.
the screw that holds the gear on the drum shaft.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Yes I know how to remove it I use its service manual because it is my first time to deal with this big machine, before I was manage to fix replace yellow cartridge issue so now I have the code error mentioned, About the drum its okey it rotate, On my service manual I was try to search for those Sensor I discover things like this. on link ir 6800
remove those units inspect/clean or replace them/
how old is Drum/ was it ever replaced ?/ how many copies on 6800 ?
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Reply With Quote
Bookmarks