Hello,
I need your help on this printer when I turn it on it start waming up when it start initializing the whole system it stuck and pring this error message.
Sam From Tanzania E.Africa
Hello,
I need your help on this printer when I turn it on it start waming up when it start initializing the whole system it stuck and pring this error message.
Sam From Tanzania E.Africa
Try a component called the primary corona.
Are you a tech?
Screwtape from the United States of America.
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
Yes Iam a Tech, I have try primary Corona its ok because when I turn on printer its start rotate,
****************Replace the primary corona assembly
will rotate until potential control is measured =then Error 061-0008 > dark area Pot.Adj too low
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
If you change the Primary this will sort. Also check your wiring into he machine frame connector block for the pot control. These are pulled in and out frequently so all connectors involved with pulling the process assy out are a issue. Check also discharge lamp connector above the cleaner blade and make sure there clean. Is the blade cleaning ok?. If you turn off Pot Control what sort of copy do you get?. Sometimes turning P/C off then on rectifies problems. Good luck!!
Just replace the corona.
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
Bookmarks