iR 6800 Error E000061-0008

**samsogoye** · 08-09-2010

Hello,
I need your help on this printer when I turn it on it start waming up when it start initializing the whole system it stuck and pring this error message.
Sam From Tanzania E.Africa

**SCREWTAPE** · 08-10-2010

Try a component called the primary corona.

Are you a tech?

Screwtape from the United States of America.

**samsogoye** · 08-10-2010

Yes Iam a Tech, I have try primary Corona its ok because when I turn on printer its start rotate,

**teckat** · 08-10-2010

****************Replace the primary corona assembly

will rotate until potential control is measured =then Error 061-0008 > dark area Pot.Adj too low

**samsogoye** · 08-10-2010

Originally Posted by teckat

****************Replace the primary corona assembly

will rotate until potential control is measured =then Error 061-0008 > dark area Pot.Adj too low

Thanks o much for your contribution , So the The primary corona assembly should be changed what about dark area pot.adj too low what am I suppose to do?

**Paul 75** · 08-10-2010

If you change the Primary this will sort. Also check your wiring into he machine frame connector block for the pot control. These are pulled in and out frequently so all connectors involved with pulling the process assy out are a issue. Check also discharge lamp connector above the cleaner blade and make sure there clean. Is the blade cleaning ok?. If you turn off Pot Control what sort of copy do you get?. Sometimes turning P/C off then on rectifies problems. Good luck!!

**teckat** · 08-10-2010

Originally Posted by samsogoye

Thanks o much for your contribution , So the The primary corona assembly should be changed what about dark area pot.adj too low what am I suppose to do?

either Primary unit is Bad or Drum surface is poor / simple deduction

**SCREWTAPE** · 08-10-2010

Just replace the corona.

**samsogoye** · 08-10-2010

Originally Posted by Paul 75

If you change the Primary this will sort. Also check your wiring into he machine frame connector block for the pot control. These are pulled in and out frequently so all connectors involved with pulling the process assy out are a issue. Check also discharge lamp connector above the cleaner blade and make sure there clean. Is the blade cleaning ok?. If you turn off Pot Control what sort of copy do you get?. Sometimes turning P/C off then on rectifies problems. Good luck!!

When it finish warming up it start rotating the whole system after 2 to 3 seconds it stuck and bring the error message, by that way it cannot print .