Canon ir 105 Problem

[SCREWTAPE]

As mrfixit noted for the E69
Replace the transfer sep corona.

[jzheld]

Thanks a lot, going to replace it tonight

[macuk]

check for wear on the fuser pressure roller and bearings as well. The metal filings have been known to get into bearings and interfere with the bias on the upper fuser roller. this can give E069 as well.

[Canuck]

check for wear on the fuser pressure roller and bearings as well. The metal filings have been known to get into bearings and interfere with the bias on the upper fuser roller. this can give E069 as well.

If you put the plastic collar on backwards this is what happens...the end of the upper fuser roll rubs and shaves off aluminum. Fuser bias shorts to ground, The contacts at the rear of the machine that the transfer contact pin on the drawer plugs into get deformed alot

["Harvey Dent"]

I've seen this happen on a IR8500

[20YRSEXP]

E-069 can also come from a fixing bias short. The bushings could be in backwards or broken. The reboot this device message can be reset, but it's been a while since we had one of the messages. I am sure someone in here knows where it is located. Maybe in the service mode or thru additional functions.

[alysson]

behind the corona transfer, the outside behind the main car is a concetor which causes error 0069. remove the screw and pull out the plug and reboot the machine. I have had this problem and pulled the plug out, the machine worked. this connector oxidizes and goes bad.

[jzheld]

No e69 anymore but still saying reboot this device...

[teckat]

No e69 anymore but still saying reboot this device...

Select "Additional Functions", then "System Settings" you will notice that the "Clear Message Board" soft switch is highlighted then select "Clear Message Board". To prevent the message from returning, open the Remote User Interface (RUI) by entering the copiers IP address in an Internet Browser address window, select "Additional Functions", then "Edit". Un-check the "Status Display" and "Pop-up Window" boxes.

If the message persists then enter Service Mode > Copier > Function > Clear > MMI select the OK key and cycle the Main Power Switch. Be aware that all user mode settings will be cleared.