u need to re-inspect / replace all Clutches used for paper p/u & delivery
also inspect the connectors to them
The Virtual Repairman's Technical Reference
How to check resistance (continuity) in a component-
use link below
How to check resistance with a multi-meter
how many prints on your machine/ u seem to have many stationary jams in your previous posts
The 0118 jam code is a delay/stationary jam from PS60. Some known fixes to the 0118 jam code are as follows:
- The wire is pinched and cut inside the wire harness of the Pre-Registration Clutch [CL5]. This prevents the Vertical Path Roller from moving smoothly causing Z-Fold jams which occur at the right door and/or Fuser Area.
- Replace roller FB4-1420-000. This part is not marked in the parts catalog but can be found within Figure 102-1 Internal Components . Look one shaft below item #20 and above item #4, center at level of 3rd binder ring of parts book.
- Replace PS60 sensor flag and bracket FF6-1516-000 and sensor PS60 FH7-7394-000.
- Check vertical path sponge rollers and shafts for worn bearings or bushings out of position. The "C" clips can also come loose and cause problems.
- Replace CL5 FH6-5016-000.
Bookmarks