After getting the 0007-0001 code, I went through the procedure of re-aligning both the belts. Unit fired right up and rent into ready state. 2 copies later the code was back.
Ideas?
After getting the 0007-0001 code, I went through the procedure of re-aligning both the belts. Unit fired right up and rent into ready state. 2 copies later the code was back.
Ideas?
Carefully inspect the Fixing and Pressure Control Motor Gears for Damage
u probably have a missing or broken tooth on one of the drive parts-Fixing Belt Control Motor Gears/Pressure Belt Control Motor Gears
/click on pictures-
gear.JPGgear2.JPG
iR5180 Fuser gear 20t.JPGspring.JPG
check that spring position in pic above
It is recommended that the most recent System Software be installed on the engine to ensure that all Fixing Assembly performance software countermeasures are implemented.
that alignment rarely works
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
I ordered all 3 gears. In order to meet the min. order amount I had to order several so if anybody needs a set... I have them.
u probably have see these old E007 PUBs
>>>E007 TP07-1.pdf Fixing Unit_TP07-168.pdf
CHECK THESE PICS >>> Important to check> click on pic for view
E007.JPGE007_1.JPGE007_2.JPGE007_3.JPGE007_4.JPG
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks