iR600 Static on Paper

[blackcat4866]

That sounds a little like an apology, but I don't require one. I've already come to my own conclusions.

You may want to apologize to teckat, Screwtape, and the others that tried to help you with your problem.

[slybot]

Some solutions were provided earlier to static issues/ U did not reply if U used any of the suggestions / some afterward reply's here were not directed to U .

Simple solution is >U can unsubscribe to a posting when U have tried the suggestions offered, if they do not work, Re-Post a new thread for what U discovered and resume help on your or another issue.

No one in this forum can read minds yet, or at least I don't think so.
Everyone's location or phone issues are usually not revealed in their postings.
If and when U have a communication issue > Please note it on your Posted request.
That advise should be noted to all Posters in the Forum.

good point; not a silly idea either in a lot of ways, 'specially if your out bush for a few days

[mrfuser]

My fellow technical guru's, my most humble of apologies to all whom I may have offended unknowingly. It was not my intention to bring grief and sorrow to this most humble of technical abodes. Please accept this apology and may you all live long and prosper!

By the way, still got static and went through everything. I am not, however, going to lay a dryer sheet on this clients machine as they would certainly have a coronary!

My most grateful acknowledgements to all herein who post with virtous, yet spongey in the middle goodness!

[Canuck]

Sheet is between finisher and the machine....the customer doesnt even know its there. If the machine is grounded PROPERLY and all the static eliminators are good(replace them dont assume they are good)then ?

[mrfuser]

FYI: It is in a controlled environment room, so humidity is controlled nicely and it is on a tile floor. No carpet.

[teckat]

FYI: It is in a controlled environment room, so humidity is controlled nicely and it is on a tile floor. No carpet.

then u better check for proper grounding at outlet = Neutral to GD =v0.0/0.5
then u need to check for proper grounding in printer / as in static eliminators/grounding leaf plates in position/ copyboard glass leaf=grounded to metal frame edge/ u should know these areas from training or manual.