Need Help for IR105

[teckat]

Teckat, regarding the image toward one side, Is it will cause by this clutch "FH6-5017"

that clutch # FH6-5017 is CL20
it is part of the DEVELOPING DRIVE ASSEMBLY =FH6-5017-020

[Canuck]

i m not a canon tech...i just learn little bit of repairing knowledge....and i dun hv sevice manual....E594 what should i do? I replace the vertical path roller and clean all the clutch and parts...already...The machine at 1st can run..but paper jam at 0105 and 0214...now it become E594
By the way, after replace DC...image or text print out become more upper, leave 1 cm blank on bottom...what should i adjust? Hope you guys can help me..

I see in this earlier post that you replaced the DC-Con,and that is when the mis-registration started. Did you do a Dcon clear after replacing the board? This is mandatory

[addoncopier]

Before i replace the DCON, already have this problem..

[teckat]

CALL IN AN EXPERIENCED CANON TECH/

this is a procedure problem=
Observation - Inspection - Testing - Elimination - Re Test - Repair/Replace.

if not followed / u will never solve