whenever i on my machine from standby mode it always ask to select paper. i have already selected all paper types which i have put in trays. can u plz help?
whenever i on my machine from standby mode it always ask to select paper. i have already selected all paper types which i have put in trays. can u plz help?
i cant fully understand your point .you can set any one tray or otherwise auto option by setting standered copy function in copier setting in additional function
The only time the machine will indicate this out of stand by is when there is paper in the bypass.
How many trays do you have?
Do you print to this machine?
When you put paper on the glass what does it say. If its ltr size paper it should say LTR when that sheet is on the glass. If it says something other than that paper size then your original. Detection sensor or off.
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
it doesnt sense the paper when i put on glass untill i switch it on by on/off button. i have selected tray 1(A4) for copy. tray second(A4) for print.
i have already selected tray 1 (A4) for copy as default tray but still it asks. not every time but about 70% time ask for
In Level 2
COPIER > OPTION > BODY
SCANSLCT >Turning ON or OFF the function of calculating a scan area from the selected paper size
Copy Glass - <Setting range>
0: OFF (Determining the scan area by document detection)
1: ON (Determining the scan area by paper size)
Level 2
SENS-CNF Setting the arrangement of document detection sensors
<Setting range>
0: AB type [Default]
1: Inch type
2: A type
Level 2
COPIER > OPTION >USER
SIZE-DET Turning the document size detection function ON or OFF
<Setting range>
0: OFF (When the platen is opened, the user will not be dazzled
because the lamp does not light.)
1: ON [Default]
Common Settings
enable/disable auto cassette
select
copy/printer/Box, other (manual feed: ON/*OFF + cassette: *ON/
OFF; manual feed not applicable to printer)
consider copy/paper type: ON/*OFF (toggle)
make sure your cassette paper size selection dial is holding in place
also check>
SW4 is used to detect the state of the AB/Inch-configuration switch.
The machine will assume the absence of a cassette if it detects a combination
not found in the table. At this time, it does not move up the cassette lifter.
Since the paper size is not identified, there will be no indication of a paper size
on the control panel; when the cassette in question is selected, the machine will
indicate a message prompting the supply of paper.
If an envelope size is detected, an envelope cassette must be fitted.
CA.JPG
Last edited by teckat; 11-02-2010 at 07:56 PM.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
I've seen that SW4 act up once in a while.
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
Bookmarks