I have an iR 105 + with code E 222.
I changed the heater of the lamp exposure, as reported in the manual, but.....Nothing the machine is faulty....
Help me !
Thanks.....
I have an iR 105 + with code E 222.
I changed the heater of the lamp exposure, as reported in the manual, but.....Nothing the machine is faulty....
Help me !
Thanks.....
There is a case in the field that the exposure control PCB ass'y was faulty.
The reader controller PCB could be faulty. Check the wiring to see if its faulty .
Try these Following steps below:
1. Check the connectors J852 and J853 on the exposure control PCB for poor contact.
2. If there is no abnormality, replace the fluorescent lamp heater (FH7-4559) with a new one.
3. If the symptom still recurs, replace the exposure control PCB (FG6-1942) and the reader controller PCB (FG6-7405) with a new one in this order.
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
At the warm up, the temperature of heater of the exposure lamp go up to 80 °C.....
Then, when the machine is ready, it begins to descend at 58 °C and the error code it's display ! ! !
I changed the heater and the lamp ! ! !
Bookmarks