I found the error code E010 on a machine ir 5000. What should to do.
Thank's
I found the error code E010 on a machine ir 5000. What should to do.
Thank's
1. When the main motor drive signal (MMON) goes ‘1’, the main motor starts to rotate.
2. When the main motor rotates, clock pulse signals (MMFG) are generated. If the DC
controller PCB detects an error in clock pulse signals, it will indicate “E010” in the control
panel.
Connector
Check if the connector of the main motor is connected?
Main motor (M2), DC controller PCB
When the Start key is pressed, does the voltage between J108-A6
(+) and J108-A8 (-) on the DC controller PCB change from 0 to
about 5 V?
YES: Replace the main motor.
NO: Check the wiring; if normal, replace the DC controller PCB.
E010-0000= The clock pulses do not arrive for 2 secs or more after the main
motor drive signal (MMFG) has been generated.
Controlling the motor to a specific speed.
Check-
Waste toner feed screw
Cleaning assembly
Registration roller
Manual feed pickup assembly
Left deck feed roller 2
Developing assembly unit
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Thank you for your answer.
At first, when copying the paper jams in the middle of fixing followed by a buzzing sound.
If every time copying, there is buzzing sounds, then the paper will jam in the fixing which will issue an error code e010.
In the field, this error code was displayed because the hopper stirring motor (M9) was broken.
If so replace the hopper stirring motor with a new one.
FH6-1434 MOTOR, DC, 4.3W
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
Bookmarks