iRC 5185 finisher W2 problem

[Apach]

Today after few clamings job finisher stop working. After turnig OFF and ON few times...finisher dont work. I heard only easy click inside finisher in level of B tray. On mainbord from finisher only red LED 1 blinking. Someone know what is problems ?
I check staple and clean inside finisher but all is OK.

Tnx

[zoraldinho]

Today after few clamings job finisher stop working. After turnig OFF and ON few times...finisher dont work. I heard only easy click inside finisher in level of B tray. On mainbord from finisher only red LED 1 blinking. Someone know what is problems ?
I check staple and clean inside finisher but all is OK.

Tnx

Try to turn off copier and move trays up and down with your hands.Use screwdriver to release tray.

[Apach]

Main unit put finisher in limited mode and all papers go to tray B. Trays go up cca 3cm but down dont work.

[charm5496]

you need to take it out of limited functions mode and cycle the power. Did you get an error code at any point in time?

[Apach]

Only first time when Im asked to shutdown and accept limited function but I dont write code. In service mode I found only error code for jamming paper, but now paper passing from finisher directly to tray B without problems. Before tray's go up and down 1cm each time when Im printing. At the moment tray stay on same position and I heard small click each time when I powered mashine. How to take it out from limited functions mode?

[Canuck]

Additional Functions,Common settings i believe.Set to off then reboot machine. Keep the waste or recycle bins away from under the finisher tray

[teckat]

Only first time when Im asked to shutdown and accept limited function but I dont write code. In service mode I found only error code for jamming paper, but now paper passing from finisher directly to tray B without problems. Before tray's go up and down 1cm each time when Im printing. At the moment tray stay on same position and I heard small click each time when I powered mashine. How to take it out from limited functions mode?

Finisher-W1 / Saddle-Finisher-W2 / imageRUNNER-C5180 / C4580 / C4080


At power on, tray 1 of the Finisher-W1 or Saddle-Finisher-W2 can not find home position.


The home position of tray 1 is detected by tray 1 paper surface sensor (PI114) and home position of tray 2 is detected by tray 2 paper surface sensor (PI115).

When the paper surface sensor flag binds on the shaft then sensor PI114 can not detect tray 1 home position. Release the flag and check the position of the PI114 to remedy the tray 1 home position detection.