i an\m facing the problem in canon ir-6000 showing the massage reset unit 1 not make copy and red error light is blinking any body help me thank you .
i an\m facing the problem in canon ir-6000 showing the massage reset unit 1 not make copy and red error light is blinking any body help me thank you .
The message Reset Unit 1 appears after the imageRUNNER boots up. This message can be caused when the imageRUNNER is unable to see the Fixing / Feeding Frame assembly. You should check the connectors for the Fixing / Feeding Frame and also the wiring between the connectors on the rear frame and the DC Controller. Sometimes the pins can become damaged or paper can get lodged inside of the connectors. If the connectors and the wiring are ok, the DC Controller may need to be replaced.
You check this first.
Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLC
here are pics of what SCREWTAPE mentioned
Connector02.jpgConnector01.jpg
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Sorry, I know it was an old post. But I still having trouble with it.
Already check the connector, replace DC. Check Wiring, switch behind the handle.
Still Reset Unit 1.
Help me. 2 machine with this problem.
Another confirmation here of listening to what teckat and Screwtape have said.
This issue is almost always with a dodgy connector on the back of the fixing/feeder frame assembly.
You can sometimes find removing the screws from the connector assembly at the rear of the fuser (right side connector looking at pic 2 in teckats photos) and packing it out with a couple of washers behind it before screwing back in place. This will make the connector fit more securely into the rear connector in the back of the machine. Do this if the problem is a bit intermittent rather than a constant indication.
But whatever you find it will be poor wiring or connector between the fixing/feeder frame unit & the DC Controller. I've never had to replace the DC Cont to fix it yet.
Had this exact fault a few weeks ago. It turned out to be the small micro switch that detects the unit 1 handle is in the home position, simply bend the switch arm so it makes better contact or replace the switch.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
You metered the switch? For continuity? Is there voltage at the switch? Have changed a few switches on these
Bookmarks