Mostly 0107 you say? That is late to fuser delivery sensor. Check the actuator inside the fuser...plastic warps and i've seen paper pass right over the actuator. Any E-007 errors logged? Also take a look at registration sensor actuator before registration roll. If worn badly(and they do) it will set up timing jams,causing reg clutch to turn on late and delaying transport to fuser. Makes it thru the reg timing window, but not the fixing sensor .
I had a case where the fixing film assembly was swollen from the heat and replacing the film did not well for me, changing the entire fixing film ass,y did my trick, I never throw away the used ones, they very often comes in handy just friday had to use, the heating element for another machine.
if there is to much grease, the films tends not to rotate, u need a grease that can keep up with the temp and run sot when heated.
How about the uniflor 8172 grease? but i still look for this grease in the market.
I mean to lubricate the fixing film
is it true that ir4570 had duplex problem when running on a4 size(70gsm)?
Product : imageRUNNER 2230 / 2270 / 2830 / 2870 / 3530 / 3570 / 4570 Title : Where is the CL6 Duplex Clutch Located in the iR3570 & iR4570?
Where is the CL6 duplex clutch located in the iR3570 & iR4570?
Answer :
There is not a CL6 duplex clutch in the iR3530, iR3570 & iR4570. This is not meant to be a trick question. It is easy to misinterpret the documentation regarding this clutch in the parts Catalog. The following parts catalog pages show the confusion. Neither page indicates which Main Drive Assembly is for which machines. (Note: The words in red are not listed in the printed catalog.)
If you are having a duplex drive problem on an iR3530, 3570 and iR4570 look to the M10 Duplex Drive Motor located on Figure 261. The M10 stepper motor is part of the Fixing Paper Delivery Drive Assembly.
Check if the Duplex Guide on the 3 Way Unit is damaged or not mounted correctly.
Duplex.jpg
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
seems like the duplex guide don't have any problem. the single side print was ok, but after the paper across the duplex unit to print the second side, the paper will jam at the drum unit before reach the fixing assy. the paper will look like a curve and it goes right inside the drum made it stuck. i wonder if the paper get too hot when it first across the fixing assy make the paper get a curve.
yr film is original or compatible ?
Bookmarks