Hi Guys ,( info required)
I have an IR 3045 that prints out A3 copies with a ripple along trailing edge side (last 2-3 inches) , have changed fuser film and pressure roller , replaced feed assm ,and reg flag arm etc. A4 copies are fine , Cheers.
Hi Guys ,( info required)
I have an IR 3045 that prints out A3 copies with a ripple along trailing edge side (last 2-3 inches) , have changed fuser film and pressure roller , replaced feed assm ,and reg flag arm etc. A4 copies are fine , Cheers.
Do you have finisher?
Practice makes perfect
If it ain't broke, don't fix it
A picture is worth a thousand words
If you want something done right, you have to do it yourself
Yes , it has a Q4 finisher and bridge unit , must admit I haven't tried without them on, there are no signs of any obstructions and both paper paths have been cleaned
i have the same problem. i change heat roller, pressure roller, paper feeder of a3 cassete,
and the printes makes a rippled copies A3, along trailing edge side (last 2-3 inches)
31032011224.JPG
this is my problem
Pop the plate off of the top of the right door and set Option>Acc>out-try to 1, restart copier, and choose that exit for paper. Run it that way to see what happens...
Check if the 1st paper delivery flapper is broken in the 2nd delivery frame assembly.The part, FL2-1212-030 can be seen in the image below.
Flapper.jpg
part tends to break at the point where the solenoid actuates the flapper.
Flapper2.jpg
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Go into service mode level 2 options, body and look for FXSP type of name, this is the fuser speed setting, set it to 3.
tanks for eveybody
was right canonbloke. when I change the speed of fuser, the rippled disapear.
Bookmarks