my cousin have an IR6570. he is facing a problem
the device shows e00004-00103
he has checked LH, POwer, HT PCB board etc and all seems normal
Please help
my cousin have an IR6570. he is facing a problem
the device shows e00004-00103
he has checked LH, POwer, HT PCB board etc and all seems normal
Please help
E004 -The IH power supply is faulty/the IH control mechanism is faulty.
After correcting the fault, be sure to reset the error.
(COPIER>FUNCTION>CLEAR>ERR)
0103 The IH current is faulty. (no current)
Check fuse in the Fixing Heater Power Supply
Check the IH Cable Guide unit
1. Re-fit all the connectors of the Fixing Heater Power Supply PCB.
2. Replace the Fixing Heater Supply PCB with a new one.
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Product : imageRUNNER 5070 / 5570 / 6570 Title : E004-0103 Error Code Error :
The fuse in the Fixing Heater Power Supply keeps blowing causing E004-0103 code.
The Fixing Heater Power Supply, the Fuser Heating Element and the DC CON pcb have all been replaced. Wall voltage at the wall outlet is within specification.
Workaround :
In this case, replacing the AC Driver PCB Assembly resolved the service issue. The part number for the AC Driver PCB Assembly is FM2-3043-000.
also you could try...
Problem :
When the machine is powered on it displays an E004-0103 error code.
Solution :
To correct this issue the IH Cable Guide unit was replaced (part number FM2-3063-000). This part can be found on figure 106 item number 11 in the imageRUNNER parts catalog.
Figure 106 on parts manual, item 11 IH cable guide unit, hope this helps.
Hello all sorry for a late reply. the problem is not solved
the present situation is
IH board, HT board, PCB board, AC Driver Board, Main Board, heater section every thing checked with another machine and seems normal.
Display comes in normal condition when the heater section is detached. we can make reserve copies...etc. in the memory.
when heater section liver is closed the error e004-0103 comes immediately. what could be that?
(when the liver closed the relay in IH board is triped - is there any sensor damage or wiring damage
kindly help
Internal Connectors/Wiring need to be check for grounding to frame/short
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Bookmarks