so this does not work--
To put the unit into download mode start with the power off.
Press and hold the 2 key only on the ten key pad and then power on the copier.
This puts the machine into the download mode. The screen will display Initializing.... for a few moments and then display Download Standby.
This method of getting into download mode can be used to recover a failed upgrade or to try to flash a machine that will not boot up and come to ready.
if applies to you----Take the PCL PCB out of the machine. -- then see if u can get into download mode, if so, power off, put back PCL and restart printer again.
Connection
iR1018 / iR1018J / iR1022A / iR1022F / iR1022i / iR1022iF
1)
Turn off the main power switch of this machine,
and then disconnect the cables connected to this machine.
2) Connect USB connector (
USB A to B) on the back of this machine to the PC using the USB cable.
g703CiNN25-F.jpg
1.
Turn on the power switch of the PC/Laptop and start SST.
2. Select "iR1022" in "Model List".
3. Double-click the "System" folder in "Model List" to check the system software version. Select "USB" in "Interface", and then click the "START" button.
4.
Now Turn on the power switch of the host machine.
5. Press the following keys on the control panel to enter the service mode.
press *Additional Functions Key >
[ then #2key then #8key ]> then *Additional Functions Key
6.
Using the plus (+) or minus (-) key, select "#DOWNLOAD".
7. Press the OK key on the control panel to place the host machine in the downloading wait mode ("#DOWNLOAD CONNECTED" is displayed).
8. Press the OK button on the SST screen displayed on the display of the PC.
install the BootROM first
then System
then PCL-16M [UFR II LT] or PCL-32M [Network Printer Kit-M1]
Bookmarks