hi...i need help for canon ir1018...this machine displaying download standby...anyone has the firmware for this machine?
i have the ir2016-2020 firmware but i don't know if it is work with ir 1018.....
thank you
hi...i need help for canon ir1018...this machine displaying download standby...anyone has the firmware for this machine?
i have the ir2016-2020 firmware but i don't know if it is work with ir 1018.....
thank you
You should start looking for firmware for your model IR1018.
Is this a variant of the IR1022?
If so, then I have had 2 give me that symptom. I am working from memory here, but there is a jumper under the CMOS battery on the controller that you can short to get out of download mode.
I will look it up when I get a chance to fire the work laptop up.
I am now off to drink lots of Highland Park Whisky with some local Belhaven Best beer to chase it
Yes, I am a nerd.
Gaming PC - check. Raspberry Pi - Check. Custom ROM on phone - check. Thick glasses - check.
hi...thanks guys..mr canonsco thank you for reply ..yes it is a variant of the ir 1022..is this jumper locating on DC controller?so there is no need for firmware if this short work...
thank you
best regards
Same problem...tnx guys..
imageRUNNER 1023iF / 1023N / 1023
Machine powers up and Download Mode is displayed
Short the two pins at JP141 on the Image Processor Board. This can be done
with a screwdriver or an alligator clip.
This will reset the machine so system software can be re-flashed.
PIN.JPG
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
thank you very much indeed mr teckat for the help info...i will try it.but there is a question please should i reload a new firmware after short the pins...if yes where it is can be found?
thank you again...best regards...
thanks ...i will try and let you know my dear..................
Bookmarks