The paper has jammed CANON iR6570/5570

[gensys]

Hi <techkat> - my friend

After initialization of sensor controls the error passes but when the mashin reboots or joins - is switched off
again gives out an error 0014 even at disconnected ADF, can??? sets factory defaults may by?
Thanks !!!!!

[teckat]

Hi <techkat> - my friend

After initialization of sensor controls the error passes but when the mashin reboots or joins - is switched off
again gives out an error 0014 even at disconnected ADF, can??? sets factory defaults may by?
Thanks !!!!!

E014 is a Fixing Unit error/check LFR/Fuser roller bearings

also check that the front door switch sitting correct.
Check & Adjust the magnet on the front door to depress the front door switch fully.

door switch not being closed correctly will cut the 24v to fix motor

[gensys]

teck kat my fiend
see

DSC00035.JPG


DSC00036.JPGDSC00037.JPG



Thanks for all

[mrfixit51]

As I previously stated,, the E014's are caused by the fuser, not a Document Feeder. As Teckat and I have stated, look to your fuser area for a solution...

[teckat]

U HAVE A FUSER ISSUE/
Either remove it to inspect-
or ignore it/ it's your choice

Flip a coin= Heads I Win/Tails U Lose

ERROR CODE:
E014-0000 (fixing motor error)
After the fixing motor has gone on, the machine does not detect the phase lock signal for the fixing motor for
2 sec or more.

The PULL lock signal of the fixing motor
does not arrive for 2 sec even when the
fixing motor has been turned on.

- Check the connector for any fault in connection.
- Replace the motor. M3: fixing motor

[gensys]

Thanks for ALL

[gensys]

Thank for All

[mrfixit51]

Problem resolution is a good thing!! ;-)