Need HELP>>>>
I've been replace the scanlamp for iR8500.
then Error E220 showed up.
i tried to use the old Scanlamp and everything is normal ( it lights red first about 2 sec in the outside of the lamp then become Green)
Please help me...
Need HELP>>>>
I've been replace the scanlamp for iR8500.
then Error E220 showed up.
i tried to use the old Scanlamp and everything is normal ( it lights red first about 2 sec in the outside of the lamp then become Green)
Please help me...
E220
Main cause The fluorescent lamp activation is faulty. The light adjustment sensor is
faulty. The light adjustment control PCB is faulty. The inverter PCB is
faulty. The reader controller PCB is faulty.
Condition
0000 The fluorescent lamp does not reach a specific intensity within 10
sec after it is turned on (if the room temperature is 10
°C or lower,
within 60 sec). Or, the activation detection signal (FL-DTCT) does
not go OFF within 5 sec after the fluorescent lamp is turned off;
during shading adjustment, the activation detection signal (FLDTCT)
does not go ON within 60 sec after the fluorescent lamp is
turned on.
MAke sure the heater is in the proper position it has to line up
B
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
what black plate ???
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Black plate you mean, the lamp cover? ( antireflection plate)
You need service manual?
< email me at mel2tobpinai@gmail.com.
Bookmarks