E220 iR8500

**bakaoni666** · 02-19-2011

Need HELP>>>>

I've been replace the scanlamp for iR8500.
then Error E220 showed up.

i tried to use the old Scanlamp and everything is normal ( it lights red first about 2 sec in the outside of the lamp then become Green)
Please help me...

**CT Copier Repair** · 02-19-2011

E220

Main cause The fluorescent lamp activation is faulty. The light adjustment sensor is

faulty. The light adjustment control PCB is faulty. The inverter PCB is

faulty. The reader controller PCB is faulty.

Condition

0000 The fluorescent lamp does not reach a specific intensity within 10

sec after it is turned on (if the room temperature is 10

°C or lower,

within 60 sec). Or, the activation detection signal (FL-DTCT) does

not go OFF within 5 sec after the fluorescent lamp is turned off;

during shading adjustment, the activation detection signal (FLDTCT)

does not go ON within 60 sec after the fluorescent lamp is

turned on.

MAke sure the heater is in the proper position it has to line up

B

**teckat** · 02-20-2011

Originally Posted by bakaoni666

Need HELP>>>>

I've been replace the scanlamp for iR8500.
then Error E220 showed up.

i tried to use the old Scanlamp and everything is normal ( it lights red first about 2 sec in the outside of the lamp then become Green)
Please help me...

Did u Complete the CCD-ADJ, LUT-ADJ and LUT-ADJ2 adjustments
make sure the Fluorescent lamp is mounted correctly with opening to the left.

Check and make sure the Inverter PCB is correctly grounded

**bakaoni666** · 04-28-2011

Originally Posted by teckat

Did u Complete the CCD-ADJ, LUT-ADJ and LUT-ADJ2 adjustments
make sure the Fluorescent lamp is mounted correctly with opening to the left.

Check and make sure the Inverter PCB is correctly grounded

It's work. But i took the black plate above the lamp. is it ok? because if i put it the scanner didn't want to move. Sorry for late confirmation. Thanks a lot.
I'm looking for iR8500 Service manual ... Do you have it?