Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
100+ Posts
- Rep Power
- 30
Canon IRC3200
Hi guys,
I have a problem with maybe machine margin adjustment. I can scan/copy well when i placed papers on the mirror of the machine. But, when I using ADF, then I scan, I can't get full page of the documents; only in the middle. It's mean that, I only can scan/copy of the middle of the documents. help me how to adjust the ADF margin.
-
You can try the doc stop adjustment in service mode that's, feeder / adjust / doc stop.
-
SERVICE MODE
FEEDER>ADJUST>DOCST
• Increasing the value makes the leading edge blank smaller.
Adjustment –100 to 100 (0.337 mm units)
Operation
1) Place the document on the ADF document tray.
2) Select the item, use the numeric keypad to change the setting value, then
press the OK key to set it.
3) Press the OK key again to deliver the document and stop it (aligned left)
on the platen glass.
4) Open the ADF carefully, and check the stop position of the document.
Standard: Stop position L4 = 0 ± 1 mm
L4: Distance from vertical size plate edge to document edge
Dip-switch functions
The dip-switch (DSW1) functions of the ADF controller PCB are as follows.
Normal settings Normal operation status is when all bits are OFF.
Document tray adjustment=
1) Set bits 3 and 4 ON.
2) Set the document tray to the following sizes and
press the push switch.
· A/B: A4
· Inch: LTR
3) Set the document tray to the following sizes and
press the push switch.
· A/B: A4R
· Inch: LTRR
4) Press the push switch (SW1) again and set all bits
back to OFF
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks